+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2)
+--- Thread: mixing resins (/showthread.php?tid=1001)
mixing resins - l200mike - 08-07-2021
hi all just a quick question i am using water washable resin from elegoo i have some gray and blue not enough to make a print can i mix the resins so i can do the print without any problems
thanks mike
RE: mixing resins - mzanetti - 08-09-2021
I do mix different resins. Shouldn't be a problem. However, the exposure times might need to be adjusted. I normally just pick something in between of the exposure times of the resins I mix, but depending on the level of detail you expect, or the complexity/stability of your model you might want to do a calibration print first to find the proper exposure time for the mix.
RE: mixing resins - l200mike - 08-10-2021
(08-09-2021, 01:20 PM)mzanetti Wrote: I do mix different resins. Shouldn't be a problem. However, the exposure times might need to be adjusted. I normally just pick something in between of the exposure times of the resins I mix, but depending on the level of detail you expect, or the complexity/stability of your model you might want to do a calibration print first to find the proper exposure time for the mix.a big thanks will try a print
mike