+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2)
+--- Thread: Printing problem (/showthread.php?tid=1006)
Printing problem - Penthesyle - 08-18-2021
For some time now I have been experiencing printing problems, nothing comes out correctly. I changed the tray, thinking that this was the problem. But nothing changes.
Either the figure comes off and stays in the tray or it comes out like on the picture. I don't understand where the problem comes from. I have an Elegoo mars for a long time and I use the grey resin
thank you in advance for your help