(10-11-2021, 01:39 AM)jasonthelamb Wrote: I've had my Saturn since March of this year, and it was working fine. I put it away for a few months as I wasn't around to print anything, but I set it up about a week ago - and I've been running into issues when trying to print.
When I test exposure or clean the bed, the entire UV light turns on as expected, however - when I actually run a print, the middle of the UV light doesn't turn on.
Images:
https://i.imgur.com/PPetGd7.jpg - Print, Middle not on
https://i.imgur.com/dEwWrkN.jpg - Exposure Test, all on
https://i.imgur.com/0AJ5hWZ.jpg - Bed Clean, all on

(10-11-2021, 01:32 PM)billtodd Wrote:

(10-11-2021, 01:39 AM)jasonthelamb Wrote: I've had my Saturn since March of this year, and it was working fine. I put it away for a few months as I wasn't around to print anything, but I set it up about a week ago - and I've been running into issues when trying to print.
When I test exposure or clean the bed, the entire UV light turns on as expected, however - when I actually run a print, the middle of the UV light doesn't turn on.
Images:
https://i.imgur.com/PPetGd7.jpg - Print, Middle not on
https://i.imgur.com/dEwWrkN.jpg - Exposure Test, all on
https://i.imgur.com/0AJ5hWZ.jpg - Bed Clean, all on

Sounds like an LCD fault to me . Can you get eyes on the lamp from the side plate ?

(10-13-2021, 03:02 AM)jasonthelamb Wrote: Talked with Elegoo support and figured it out... 100% my fault, was using the wrong power supply and the light board wasn't getting enough juice.