+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: What I wanted vs. what I got (/showthread.php?tid=1094)
What I wanted vs. what I got - VivaTerlingua - 02-07-2022
Hello brand new to resin printing and a bit frustrated so far. I was trying to print the part on the bottom. What I got was the supports still attached to the build plate and the piece in the middle of the picture in the resin tank. Using a Saturn printer with Elegoo plant based resin. What parameters should I be looking at changing?
![[Image: 7VHLXlO.jpg]](https://i.imgur.com/7VHLXlO.jpg)
RE: What I wanted vs. what I got - cliffyk - 02-08-2022
What exposure times are you using? My first thought it is too short...
RE: What I wanted vs. what I got - VivaTerlingua - 02-08-2022
(02-08-2022, 01:11 AM)cliffyk Wrote: What exposure times are you using? My first thought it is too short...
Thank you, that was it. Somebody on the Saturn Facebook group said the same thing. Last night I tried again, changed the exposure from 2.5 sec to 3.5 sec and it came out perfect.