change screen for a monocrhome?¿ - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1) +--- Forum: Printer Mods / Add-Ons (https://www.elegoomars.com/forum/forumdisplay.php?fid=4) +--- Thread: change screen for a monocrhome?¿ (/showthread.php?tid=1111) |
change screen for a monocrhome?¿ - ebsigma - 03-05-2022 Hello, I have a mars (1) with which I have been able to see plate v2 type C. I would like to change the screen for a monochrome one, in order to reduce printing times (in this machine I have them at a height of 0.05mm 10 seconds). I have seen the following screen: fhd mono lcd I think it is compatible with my board, but I think I have to change the firmware... my questions are: If I change the firmware and then I want to go back to my old screen, what firmware should I put... and if there is a place to compare miniatures printed with the two screens... since the mono one I think has less resolution... and I usually use it to print wargame miniatures like warhammer... Thank you. |