+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Extra "coat" defect, Mars 3 (/showthread.php?tid=1112)
Extra "coat" defect, Mars 3 - Possums - 03-06-2022
My Elegoo Mars 3 printer is just a week old. I have strange defect, which I cannot explain. From the first layers model have some kind of extra coating, which goes away at certain height.
[attachment=504]
This extra coating is quite easily brushed away in soapy water. So far I was printing only small parts and cannot confirm, if the defect was present from the very beginning. Vat has been cleaned and resin filtered, replaced. Second print has the same defect.
Elegoo mars 3, “ceramic grey water washable” resin, 0.05mm/ 2,5s
Chitubox project and sliced file for printing
https://www.icloud.com/iclouddrive/0e9s4zmsHd7g5s5TgqUL2NH6w#Extra_coat_defect
Thank you in advance for every idea ...
Possums
RE: Extra "coat" defect, Mars 3 - cliffyk - 03-06-2022
Ditch the "water washable" resin, it creates numerous problems--I.e. it sucks...