+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Printing (https://www.elegoomars.com/forum/forumdisplay.php?fid=6)
+--- Forum: Tips & Tricks (https://www.elegoomars.com/forum/forumdisplay.php?fid=9)
+--- Thread: How best to clean cover (/showthread.php?tid=1115)
How best to clean cover - jeffgar2000 - 03-26-2022
I have 3 resin printers and 1 on the way and they all stay pretty busy.
I have an Elegoo Mars original, An Elegoo Saturn, An Anycubic Photon MonoX and I have a kickstarter Elegoo Jupiter on the way soon.
Anyway, All of them have VERY grungy Reddish, Yellowish or Green Covers (my mars is the myminifactory version) on the inside where the resin splatters/migrates/not sure how it gets so bad..
I have tried cleaning with soap and water, alcohols and scrubby pads. Nothing seems to work.
Any suggestions for how best to clean the INSIDE of nasty, resin splattered covers on these printers.
RE: How best to clean cover - larsun - 09-05-2022
Amm tissue paper with IPA and elbow grease might help.