Build plate glued to the printer - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 2 Pro (https://www.elegoomars.com/forum/forumdisplay.php?fid=46) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=50) +--- Thread: Build plate glued to the printer (/showthread.php?tid=1118) |
Build plate glued to the printer - divARTsity - 03-30-2022 Good morning I have an ELEGOO MARS 2 PRO. It has been working very well for the last 4 months. Now I can't remove the build plate from the printer. Apparently it has stuck, although I have always been careful to clean it well of possible resin remains. How can I release it without damaging the printer? Is there anything I can do? Many thanks! RE: Build plate glued to the printer - billtodd - 03-30-2022 Ouch ! did you press 'clean' with the plate in the tank? unscrew tank , raise and remove tank and build plate together. drain resin , wash to make handling easier , then carefully peel tank away from build plate , scrape cured resin from plate . RE: Build plate glued to the printer - divARTsity - 03-30-2022 (03-30-2022, 02:57 AM)billtodd Wrote: Ouch ! did you press 'clean' with the plate in the tank? No, the Plate is not glued to the tank but to the arm that is moving through the rail. I cant take it away from... RE: Build plate glued to the printer - billtodd - 04-03-2022 Oh! There is a millimeter or two clearance between the rectangular socket and the Z lever. If you unscrew the knob completely you should be able to carefully twist/rock/knock the mounting free . How did the resin get that far up? Bill |