+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Mars 3 3d Printer is printing a solid layer of resin across most of the build plate (/showthread.php?tid=1202)
Mars 3 3d Printer is printing a solid layer of resin across most of the build plate - kdude15 - 06-12-2022
Hi,
As the title states, I am having an issue where my printer is printing a solid layer of resin across a large portion of the entire build plate (see attached image). It has done this a couple times now and I have tried re-calibrating the home point, cleaning both the vat and the build plate, and tried different prints. Prints that worked before.
I think it might be worth nothing that I had to fully replace the 4k screen & glass about a month ago (after it finally arrived from China), but I was able to complete a couple prints between then and now. I did have some trouble getting it to not stick to the build plate in certain spots, and even had to replace the FEP as well, but it just suddenly started doing THIS out of the blue. Obviously I don't want to waste a ton of resin so I thought I would ask around - I also emailed Egeloo support, but they can be slow.
Thanks,
Keith