My first print my first fail. - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8) +--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11) +--- Thread: My first print my first fail. (/showthread.php?tid=1206) |
My first print my first fail. - TheGrizzz - 06-16-2022 Today I tried my first print. I downloaded a Baby Yoda.stl from Thang. Using Chitubox I tried my best to set everything right. I fitted it to size, hollowed it, hole at the bottom, supports to where I though they would be needed, save it as ctb. All looked great. I printed it, 4 hours it told me but at 50% I noticed that only the supports were printed. I stopped the print empty the vat and saw only the base had printed and it was stuck to the fep. Yesterday I printed the test rooks and they came out perfect. What could I have possibly do wrong? I want this to be my new hobby. At my age there is nothing much I can do. I have been printing with Pla for a few years now and I now want to switch to resin. I have a Saturn S and am using water washable resin. Any help? Please. TIA |