First layer sticks to FEP then nothing - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8) +--- Forum: Prints Sticking to the FEP Film (https://www.elegoomars.com/forum/forumdisplay.php?fid=12) +--- Thread: First layer sticks to FEP then nothing (/showthread.php?tid=1274) |
First layer sticks to FEP then nothing - toddalanrose - 02-24-2023 I read through many threads and found ones that are close to this issue but have no actual solutions. I have a Mars 2 Pro and can no longer print anything. My test piece sticks to the FEP and stops printing after the first layer (see pics) [attachment=550]
RE: First layer sticks to FEP then nothing - Christophe - 08-12-2023 Good morning, Have you done Platform Leveling? I'm having this problem on my Saturn 3 Ultra, I think it's the same as you Warmest regards, Christophe After doing a new leveling, the 1st layer is flawless! so do the leveling again |