+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Chitubox and Elegoo Mars printing problem (/showthread.php?tid=1283)
Chitubox and Elegoo Mars printing problem - boblinux - 03-24-2023
Hello everyone,
I use Chitubox which I find quite simple for supports and slicing.I updated Chitubox (1.9) recently (I don't know if my problem is related)I do everything as usual to prepare the impression of a small simple object (a gas tank 3cm long, basically a cylinder with few details)I tilt the object, I lift it 5mm from the board, I put supports everywhere (thin)I slice, I save on key and I print....3 attempts: 3 failures: it only prints the supports and not the object.this is the first time this has happened to me.do you have an idea? Thank you in advance for your help. Philip