LCD is black, no purple light, but logo is visible (barely) - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Jupiter 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=56) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=60) +--- Thread: LCD is black, no purple light, but logo is visible (barely) (/showthread.php?tid=1295) |
LCD is black, no purple light, but logo is visible (barely) - dasmatarix - 05-25-2023 Hi there, have printed a little and its been fine, then went to print again after a while of not using it and nothing prints, did the expose test and the LCD is black, there no purple light, but logo is visible (barely). I haven't done a firmware update or anything like that, I can see that can cause an issue. Is it broken? I've tried opening it and checking the cables but I don't think any are loose. See below picture, there is one port with LED in its label with nothing plugged in, but no matching uplugged cable. I did lose the power cable, so I purchased a new one, its a 12v dc power supply input voltage: 100V-240V 50/60Hz; Output: DC 12V 5A (60W) max. https://www.amazon.com.au/dp/B07MM14TQC?psc=1&ref=ppx_yo2ov_dt_b_product_details RE: LCD is black, no purple light, but logo is visible (barely) - Suran - 12-09-2023 In your photo, the LCD cable is not seated properly. One side is sticking out slightly. |