Hello community i need help - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: General Discussion (https://www.elegoomars.com/forum/forumdisplay.php?fid=23) +--- Forum: Introductions (https://www.elegoomars.com/forum/forumdisplay.php?fid=25) +--- Thread: Hello community i need help (/showthread.php?tid=1321) |
Hello community i need help - dutchsandbox - 10-29-2023 Dear community, i am new to 3d printing I bought a Elegoo mars 4 9K, with the easy chitobox software as slicer I did level my Build Plate of the mars 4 9k I use the water washable grey resin from elegoo The room ambient temperatures is about 21 deg Celsius Settings are used conform the elego sheet But sadly, so far all al my printing fails; Only a thin peace of hard resin is stuck to the bottom of the vat i think this is called: Non-adherence For some reason the UV-expose resin does not stick to the build platform / build plate, instead the print model a flat area of cured resin on the bottom of the resin tank / VAT. How to change & which setting to strengthen the adhesion of the resin to itself to the build platform / build plate. I am a bit lost now and unsure how to resolve the issue. Any hint, tip, help to solve the issue is welcome! regards, D.S. RE: Hello community i need help - miachelbrown - 11-08-2023 [font=Söhne, ui-sans-serif, system-ui, -apple-system,]I've encountered a similar issue. I'm attempting to print models created with my 3D scanner and would like to understand how to modify settings and which settings can improve the adhesion of the resin to the build platform/plate.[/font] |