+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: New Saturn 3 12k Does not recognise when I have set Home (/showthread.php?tid=1325)
New Saturn 3 12k Does not recognise when I have set Home - spooookie1 - 11-28-2023
Hello all, I bought a Saturn 3 12k on Saturday and have just tried using it today but I cannot get it to register "Home" when I level it.
I have been using the Saturn s for 2 years prior to this and if there is one thing I seem to get right is levelling, except not on this. I go through the standard set up, I tried using the card that came with it then back to my preferred paper method and the same result. The build plate just continues down and starts grinding against the screen.
I would like to see if anyone has any simple solutions for me to sort it out, or has had similar issues before I send it back.
Thanks everyone for taking the time.