+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Printing (https://www.elegoomars.com/forum/forumdisplay.php?fid=6)
+--- Forum: ChiTuBox Slicer / Other Slicer Options (https://www.elegoomars.com/forum/forumdisplay.php?fid=5)
+--- Thread: Layer height (/showthread.php?tid=216)
Layer height - NIKOBECK - 10-15-2019
Hello,
First post here so thank you for your help
Since today, i have no potion to put a decimal to my layer heighth...
The only possibility is 1MM or 2MM or 3MM etc etc ... But the 0.1 or 0.2 or whatever is not possible to enter.
Any suggestions ?
Thanks you
RE: Layer height - MistaBreed - 11-19-2019
(10-15-2019, 01:33 AM)NIKOBECK Wrote: Hello,
First post here so thank you for your help
Since today, i have no potion to put a decimal to my layer heighth...
The only possibility is 1MM or 2MM or 3MM etc etc ... But the 0.1 or 0.2 or whatever is not possible to enter.
Any suggestions ?
Thanks you
Are you talking about the layer height in chitubox? What version?
Or are you talking about the Z-Axis manual moving chapter on your elegoo printer?
Maybe this problem is already solved?