+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: General Discussion (https://www.elegoomars.com/forum/forumdisplay.php?fid=23)
+--- Forum: Introductions (https://www.elegoomars.com/forum/forumdisplay.php?fid=25)
+--- Thread: New Mars user from Australia (/showthread.php?tid=234)
New Mars user from Australia - djsloanau - 10-21-2019
Hello from Oz. I have had my Mars for about a month, only just found this forum, but have been on the facebook page. I have been a 3D designer and animator for over 20 years, FDM 3D printing for 3, and just moved to resin mostly to get smaller models in good detail. So far all my Mars prints in Elegoo grey have been perfect, I moved to translucent and need to tweak the settings a little having had 2 failed prints, but the last one was good.