Stepper issue and leveling - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1) +--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2) +--- Thread: Stepper issue and leveling (/showthread.php?tid=355) |
Stepper issue and leveling - slammers - 02-01-2020 From new, my printer has had issues with the stepper. If I manual move the head, sometimes it sounds like the stepper is stalling. It vibrates the entire machine. It is worse going up than down. I suspect the lead screw is not aligned properly or the lead screw nut is to tight. Has anyone had this issue and have a fix? Here is a video of the sound it makes http://www.smartire.com/downloads/ElegooStepperIssue.MOV I have printed a couple parts and they seem ok, but on my fourth part, the printer started beeping when it does the first 10 layers or so. I tried re-doing the leveling procedure and when the plate gets a 5 mm above the LCD it starts beeping. I tried to manual move the z height so the plate spring is only depressed slightly and then use that Set Z function. but the Set Z seems to have no effect. If I press the goto Z, it goes further than I set and it again starts beeping. Has anyone had this issue and know a solution? Thanks Shawn |