+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2)
+--- Thread: Is this possible? (/showthread.php?tid=428)
Is this possible? - simon88998 - 03-30-2020
Hi elegoo community! Before buying a elegoo mars i have a quick question.
My understanding is that it has a max build capacity of 11.5 x 6.5 x 11.5 cm (length, width, height)
What i want to print has the following measurements: 8.1 x 8.1 x 4.1 cm (length, width, height)
Is it possible to print it vertical to be within the build capacity?
I have attached a picture of the print.
RE: Is this possible? - fromFDMtoSLA - 03-30-2020
just a Demo-Disk in Chitu-slicer
Disk is 84x84x42mm
RE: Is this possible? - simon88998 - 03-30-2020
(03-30-2020, 01:22 AM)fromFDMtoSLA Wrote: just a Demo-Disk in Chitu-slicerSo i assume its possible to rotate it and print it ?
Disk is 84x84x42mm
RE: Is this possible? - fromFDMtoSLA - 03-30-2020
yes, should be possible