+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2)
+--- Thread: Print bottom not flat (/showthread.php?tid=450)
Pages:
1
2
RE: Print bottom not flat - fromFDMtoSLA - 04-29-2020
changing the stepper-rate is only necessary if the dimensions in z-direction are differnet (modell to printed).
it has nothing to do with the leveling.
your problem sounds like a bad leveling.
RE: Print bottom not flat - Agan - 04-29-2020
I'll try again later, as soon as I can find the time. I'll post the results here.