+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: LCD Screen Failing at the end (/showthread.php?tid=562)
LCD Screen Failing at the end - Mono98 - 07-25-2020
Hello guys,
A newbie here... I don’t know how to explain the problem. But the printer almost finishing the printing the lcd starts lighting up completely. I have not tried another file because I don’t want to waste more resin it may be the file? Or the lcd screen?
RE: LCD Screen Failing at the end - cliffyk - 07-25-2020
I'm going to go with the file being bad. No need to waste resin to test it, just remove the vat and platen, placed a sheet of copy paper on the LCD and observe what goes on when you "print" the file. The printer does not know that there is no "goop" and that the platen is not there...
RE: LCD Screen Failing at the end - Mono98 - 07-26-2020
(07-25-2020, 09:47 PM)cliffyk Wrote: I'm going to go with the file being bad. No need to waste resin to test it, just remove the vat and platen, placed a sheet of copy paper on the LCD and observe what goes on when you "print" the file. The printer does not know that there is no "goop" and that the platen is not there...Thank you, lcd seems to work normally, I will try again with a new file
