+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars Pro 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=27)
+--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=31)
+--- Thread: How does this exposure test look to you? (/showthread.php?tid=676)
How does this exposure test look to you? - plate-of-shrimp - 11-01-2020
Hi,
After a failed print with the right side of the failure badly drooping, I ran Tools -> Exposure from the touchscreen. A photo of the result:
https://drive.google.com/file/d/1NaYnqtrvM725fOiKzJ3yykARWJWKxLof/view?usp=sharing
This does not look too good to me.
Has anyone encountered something that looks like this?
-r
RE: How does this exposure test look to you? - cliffyk - 11-01-2020
The right side looks completely screwed up to me. How many hours use on the machine?
RE: How does this exposure test look to you? - plate-of-shrimp - 11-02-2020
Same conclusion on my side.
Hmm, I'd say about 18 hours. The unit was commissioned only 3 days ago.
ELEGOO is sending me a replacement.
Thanks for looking.
In retrospect, I wonder if I did something to shorten the LCD lifetime; eg, I told Lychee to tell the printer something bad. Maximum layer time I have ever specified is 60s, for 5 burn-in layers.