Elegoo mars pro 2 and ECO Anycubic Resin - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars Pro 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=27) +--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=28) +--- Thread: Elegoo mars pro 2 and ECO Anycubic Resin (/showthread.php?tid=690)

Elegoo mars pro 2 and ECO Anycubic Resin - Inmel - 11-24-2020 Hello Does anyone have an elegoo mars pro 2 and use Anycubic Eco resin? If so, what exposure settings do you use? I am having problems with this resin when it comes to printing all my pieces correctly with the elegoo mars PRO 2 standard configuration, I currently use 2.5s per layer and 6 lower layers of 80. Someone uses this combination of resin and printer (Elegoo MARS 2 PROS and ECO ANYCUBIC RESIN / green Trans) and can help me by sharing their configuration? , even if it is not exactly the translucent green resin and if it is of another color it would be very helpful since it does not I am able to find any table with references for this printer on the internet or any forum. Thank you very much and sorry for my bad English. RE: Elegoo mars pro 2 and ECO Anycubic Resin - cliffyk - 11-24-2020 What problems if any are you experiencing? RE: Elegoo mars pro 2 and ECO Anycubic Resin - Inmel - 11-25-2020 Some small pieces do not stick to the base and in others the finest supports are not created with the next failure of certain parts of the miniature. RE: Elegoo mars pro 2 and ECO Anycubic Resin - cliffyk - 11-25-2020 What lift speeds are set in the Chitubox printer settings? I have found the defaults for the MARS and MARS Pro to be too high, at 100 and 80 mm/minute. The settings for best results on my MARS are as shown above...