+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars Pro 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=27)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=28)
+--- Thread: LCD Screen issues (/showthread.php?tid=709)
LCD Screen issues - Hardmaninc - 12-12-2020
Hi All
I have one of the Mars Pro 2 printers and when i plug in the USB stick the preview you get on the lcd screen has lines running down it and looks like its broken. I am wondering if any one else has had this issue and what they did to fix it ? I have done the turn off and leave power out and back on again after 30mins but still does it. So not sure what else to try ?
Thanks
RE: LCD Screen issues - Mr Sprue - 12-15-2020
(12-12-2020, 03:53 AM)Hardmaninc Wrote: Hi AllFirst thing to try is to remove the front cover and check the LCD plug is connected to the circuit board properly. That's what cured my issue.
I have one of the Mars Pro 2 printers and when i plug in the USB stick the preview you get on the lcd screen has lines running down it and looks like its broken. I am wondering if any one else has had this issue and what they did to fix it ? I have done the turn off and leave power out and back on again after 30mins but still does it. So not sure what else to try ?
Thanks
RE: LCD Screen issues - Hardmaninc - 12-15-2020
(12-15-2020, 02:01 AM)Mr Sprue Wrote:Thanks I will take a look at that.(12-12-2020, 03:53 AM)Hardmaninc Wrote: Hi AllFirst thing to try is to remove the front cover and check the LCD plug is connected to the circuit board properly. That's what cured my issue.
I have one of the Mars Pro 2 printers and when i plug in the USB stick the preview you get on the lcd screen has lines running down it and looks like its broken. I am wondering if any one else has had this issue and what they did to fix it ? I have done the turn off and leave power out and back on again after 30mins but still does it. So not sure what else to try ?
Thanks