Sticks to plate and FEP - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8) +--- Forum: Prints Sticking to the FEP Film (https://www.elegoomars.com/forum/forumdisplay.php?fid=12) +--- Thread: Sticks to plate and FEP (/showthread.php?tid=716)

Sticks to plate and FEP - Hallztein - 12-24-2020 Hello I received my Mars 2 Pro just a week ago. Printed a model and it worked absolutley perfect! With that behind me I wanted to print more of course but  next time I tried it went awful..... The strange thing is that the so called raft will be attached to the build plate but some 2-3 mm down its attach to the FEP. I have tried to level with two sheets of paper and scouring the build plate but thats not works either. I use washable resin. Have tested both chitubox and Lychee slicer bit problem is still there. I have tried to print a Batman bust, the base for the bust comes out perfect but  the bust with supports just gets problem, some on the build plate and the rest on the FEP. What could be the problem? I have tried heavy supports but same problem, the supports arr there but the rest sticks to the FEP. Hope someone here could help me out. RE: Sticks to plate and FEP - cliffyk - 12-25-2020 I don't think the resin is your complete problem--however the water washable resin sucks (see my posts here for more about that). Beyond that, what might help is reducing the lifting speed(s) in the Chitubox settings: I have found their default setting of 100 mm/minute to be too aggressive and that it can tear the raft and/or model from the hangers (lower lift speed = less force)...