add a wiper to elegoo? - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars Pro 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=27) +--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=28) +--- Thread: add a wiper to elegoo? (/showthread.php?tid=771) |
add a wiper to elegoo? - ele - 02-19-2021 Hello, I have an elegoo Mars Pro, and like to add a wiper so that I can wipe the resin vat for each layer. My thoughts are to insert a line or two g-code between each layer, for example, after each Z-axis lifting. In order to do this I will need to 1) insert gcode after each layer; and 2) get a signal (or control) from the motherboard to activate a Ramps/Arduino/actuator. I was wondering if this is possible to modify the elegoo mars? Thank you! RE: add a wiper to elegoo? - cliffyk - 02-19-2021 I have had a plain ol' Mars unit for over a year and have not seen any need for such a device. What "problem" are you seeking to resolve. RE: add a wiper to elegoo? - ele - 02-19-2021 (02-19-2021, 09:40 AM)cliffyk Wrote: I have had a plain ol' Mars unit for over a year and have not seen any need for such a device. What "problem" are you seeking to resolve.I like to cure a very thick resin that I made. It is so thick that a wiper is necessary to replenish the resin between layers. RE: add a wiper to elegoo? - cliffyk - 02-19-2021 OK... |