ChiTuBox Settings - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Saturn 4K / 8K 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=51) +--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=52) +--- Thread: ChiTuBox Settings (/showthread.php?tid=795) |
ChiTuBox Settings - ChinToka - 03-18-2021 Hi, i received my SATURN yesterday and i wanted to set it up in ChiTuBox. But unlike for my MARS i cannot find some user settings for the lifting speed etc. I so not want to use the defauilt. Any recommendations? I am using Elgeoo ABS like Grey. I am only interested in machine settings, not resin settings RE: ChiTuBox Settings - cliffyk - 03-18-2021 What version of CHITUBOX are you using? I just loaded the Saturn driver in v1.8.1 and all those settings were available. Checked v 1.8.0 beta and v1.7.0 also, both show the lift speeds and other machine settings as well... RE: ChiTuBox Settings - ChinToka - 03-18-2021 The latest one. I do not mean the standard settings but improved ones RE: ChiTuBox Settings - cliffyk - 03-18-2021 You should have said so in the first--you mentioned only lift speed. I understand now what you meant. The "other" settings are sdisabed by default in many of the printer "machine" resource files. I don't know why, perhaps they are not supported by some printers--they can be enabled by editing the resource configuration file for your printer. I have done so for my plain ol' Mars, however to be honest I do not find their so-called "improvement" to have much utility or do much of anything I found necessary. On Linux the these files are located at [CHITUBOX installation folder]/resource/machine.. In the ELEGOO_SATURN.cfg file you will find a number of entries that are typically named [something]Visible or [something]Editable--if the configuration valule is "0" that function/setting is disabled. Here is the Saturn file with such values highlighted (check the @default.cfg file too: Hope this helps--let us know how you make out... RE: ChiTuBox Settings - ChinToka - 03-26-2021 Ah, ok. So i found a recommendation to set all of the lift settings to 70. On my Mars i have the retract speed set to 150 so 70 is way lower and the prints take longer. I don not print minitaures so far, so 150 could be a better value in saving time? RE: ChiTuBox Settings - ChinToka - 03-27-2021 I started printing and i have to say i am very disappointed! When i start to print, the prints are sticking to the FEP and every time it lifts, i hear a tearing sound. I adjusted the bottom exposure time from 30-60s so it may not glue to the FEP but no use. Very disappointed with the printer so far! |