Clean platform from cured resin - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=10) +--- Thread: Clean platform from cured resin (/showthread.php?tid=807) |
Clean platform from cured resin - valerio.sperati - 03-31-2021 Please, I just bought an Elegoo Mars 2 Pro. I run unsuccessfully the first test (the chess in usb pen); this was because the build platform were not enough fastened, so it moved. Now, before running the second test, I tried to clean both the tank and the platform. Nevertheless there is a small thin film of solidified cured resin (water washable ceramic gray) on both tank borders and platform. This is hard to clean: water does not wash it, as it is cured; the film is very thin so I cannot simply peel off in one piece (the film breaks in small pieces). Is there some trick to clean the thin film of residual cured resin? Thanks in advance, Valerio |