Replacing FEP - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 2 Pro (https://www.elegoomars.com/forum/forumdisplay.php?fid=46) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=50) +--- Thread: Replacing FEP (/showthread.php?tid=827) |
Replacing FEP - Fred W. - 05-30-2021 Hi all, I'm a newbie to 3D printing and I want to replace the FEP on the resin tank of the Elegoo Mars2 pro printer. My question is about the acetate sheets. One is a thinner sheet and the other is a thicker sheet. Which one is the FEP and which is the backing sheet? Sorry if this sounds idiotic, but remember this is all new to me. Fred W. RE: Replacing FEP - Haggy - 06-01-2021 (05-30-2021, 09:31 AM)Fred W. Wrote: Hi all, Normally the real sheet is in between of two sheets . at least it was in my case. The procetive shields were really soft RE: Replacing FEP - Fred W. - 06-01-2021 (06-01-2021, 06:00 AM)Haggy Wrote:(05-30-2021, 09:31 AM)Fred W. Wrote: Hi all, Thanks for the come back Haggy. I am using the FEP replacement sheets that came with my Mars 2 pro. There was only 2 sheets that adhered to each other one thick and one thin. Which is which? RE: Replacing FEP - fromFDMtoSLA - 06-04-2021 the thin is the protction-sheet, the thicker the FEP RE: Replacing FEP - Fred W. - 06-04-2021 (06-04-2021, 08:30 AM)fromFDMtoSLA Wrote: the thin is the protction-sheet, the thicker the FEP Thanks for the clarification! It's all simple when you've been around the block once. Me, I have to go around twice. RE: Replacing FEP - Fred W. - 06-07-2021 (06-04-2021, 08:46 AM)Fred W. Wrote:(06-04-2021, 08:30 AM)fromFDMtoSLA Wrote: the thin is the protction-sheet, the thicker the FEP |