Mars 2 Pro bed refused to level properly! - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8) +--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11) +--- Thread: Mars 2 Pro bed refused to level properly! (/showthread.php?tid=831) |
Mars 2 Pro bed refused to level properly! - Vaesive - 06-04-2021 Been printing fine but during cleaning I somehow knocked the build head slightly out of alignment so running through the leveling process again but now I cannot for the life of me get the print head to level evenly and I'm losing my mind! I'm following the instructions to a T over and over and over again but one corner is always tighter than the others. I've even tried pressing on the build plate a bit when tightening the screws but nothing seems to work. This cannot be how it is expected to work, can it? Any assistance would be greatly appreciated; I'm about to throw this thing out the window Process:
May have figured it out with some testing: the right screw seems to throw everything off. Do I have a defective unit? Tightening the right screw causes the malalignment of the plate which causes a corner to become tighter than the others. If I keep the right screw untightened the bed is evenly leveled but can be shifted which makes printing impossible -.- RE: Mars 2 Pro bed refused to level properly! - Digital Darth - 06-17-2021 I just posted about a similar issue in the Mars 2 Mono section (probably posted in the wrong place). Did you ever find a resolution for this? |