10-02-2020, 10:27 PM
After printing a few sets of discs, I was finally able to print a pair of rooks. I used the lubricant method, but did poke a hole in the film... I loaded a file that was sliced with chitubox, I had a couple by this time. I pressed play and...
Received a 200000 (I think that’s the # of zeros). So I deleted all the excessive files with my computer, and tried again. All of the erased files were still visible, so I checked again and later deleted a couple from the printer. At one point I viewed the preview picture, but after deleting another file... everything turned to Chinese!!
You may not guess this, but I don’t know Chinese. The USB was now blank, so I replaced the file on the drive, and it shows as being there, but when I try to print, I’m told that the file is missing. I don’t know what to do, I tried saving a new slice... nothing, and I can’t return the print page to English.
Received a 200000 (I think that’s the # of zeros). So I deleted all the excessive files with my computer, and tried again. All of the erased files were still visible, so I checked again and later deleted a couple from the printer. At one point I viewed the preview picture, but after deleting another file... everything turned to Chinese!!
You may not guess this, but I don’t know Chinese. The USB was now blank, so I replaced the file on the drive, and it shows as being there, but when I try to print, I’m told that the file is missing. I don’t know what to do, I tried saving a new slice... nothing, and I can’t return the print page to English.