11-20-2019, 07:54 PM
HI Everyone,
Not sure whats going wrong here, but I seem to getting a lot of issues with printing.
The funnel has a hole in it (2nd pic) the frame to hold the carbon filter (1st pic) looks like it did set, but it was one of the last parts to print the rest of it printed fine.
Tried a gaslands buggy (pica 3 and 4) and parts of it just didn't print despite haves a support ready for it.
Tried a gaslands dice, and the quality was random on every side of the die, with the detail, one side barely has any.
I tried printing a gaslands template, with is basically a ruler with a few engraved numbers, and most of the details were missing on that as well.
Each print had a power cycle in between and the tray has been cleaned.
I'm running another test at the moment, with increase exposure time from 8 to 10 seconds per layer.
Any ideas?
Not sure whats going wrong here, but I seem to getting a lot of issues with printing.
The funnel has a hole in it (2nd pic) the frame to hold the carbon filter (1st pic) looks like it did set, but it was one of the last parts to print the rest of it printed fine.
Tried a gaslands buggy (pica 3 and 4) and parts of it just didn't print despite haves a support ready for it.
Tried a gaslands dice, and the quality was random on every side of the die, with the detail, one side barely has any.
I tried printing a gaslands template, with is basically a ruler with a few engraved numbers, and most of the details were missing on that as well.
Each print had a power cycle in between and the tray has been cleaned.
I'm running another test at the moment, with increase exposure time from 8 to 10 seconds per layer.
Any ideas?