(02-14-2020, 07:22 AM)fromFDMtoSLA Wrote: no, that is not normal.
which actual version of the firmware is on the printer? made any changes on the firmware?
02-15-2020, 09:45 AM (This post was last modified: 02-15-2020, 09:46 AM by Interceptor.)
(02-15-2020, 03:18 AM)fromFDMtoSLA Wrote: with Ver.: 4.3.2_LCDF = Houston we have a problem ;-) (no documents and downloads about this firmware - it's the new one for the new mainboard)
you should contact Elegoo-support
- if you are able to open the printer, you can try a reset of the mainboard - see picture
02-15-2020, 10:05 AM (This post was last modified: 02-15-2020, 10:06 AM by Interceptor.)
(02-15-2020, 09:59 AM)fromFDMtoSLA Wrote: looks like the driver for the UV-Leds is gone (MosFet on the back of the pcb)
i think, it's better to contact Elegoo-support to get a new mainboard
Today i recived a new mainboard, and the same problem...