09-10-2023, 10:04 AM
New to 3D printing. Recently purchased a Saturn Elegoo 4k printer. I've done some test prints with standard Elegoo grey photopolymer reside that came out well at 2.5 seconds exposure. I printed the cones of calibration using the same settings. The cones failed. I increased the timing of the exposure from 2.5 to 3.7 seconds. The cones printed successfully. The exposure time seems long to me as most information I've seen hangs around 2.5 seconds. Being I'm a noobie, there are other settings I don't understand or even no about.
I'm printing items to be used in an N scale model railroad. So far I've found a few files on thingaverse. I've printed some girder bridges. The bridge details are spot on and incredibly straight but some edge upward curl from the build plate.
I'm sure there are tons of variables and questions that need to be answered for assistance with my issue.
I'm printing items to be used in an N scale model railroad. So far I've found a few files on thingaverse. I've printed some girder bridges. The bridge details are spot on and incredibly straight but some edge upward curl from the build plate.
I'm sure there are tons of variables and questions that need to be answered for assistance with my issue.