Hello, has anyone tried to steer him through UART yet?
I am currently using the Ethernet Enabled firmware. Works well with chitubox. But you still don't really have control over the printer. I'm playing a bit with the UART right now and had to find out that it's easy to access via GCodes.
Any of you guys know any sources for usable gcode lists?
I post here a PDF with the G-Codes I found so far.
https://herbri.ch/pic/gcode_list.pdf
I am currently using the Ethernet Enabled firmware. Works well with chitubox. But you still don't really have control over the printer. I'm playing a bit with the UART right now and had to find out that it's easy to access via GCodes.
Any of you guys know any sources for usable gcode lists?
I post here a PDF with the G-Codes I found so far.
https://herbri.ch/pic/gcode_list.pdf