Thread Rating:
  • 0 Vote(s) - 0 Average
Lift height
#1
As someone made an updated the GCode for switching the fun during print only, would it be possible to have the build plate lift at a different height for an amount of first slices then every 100th (or more) slice? It would be great to be able to stop earlier a failed print.
Reply
#2
Unfortunately there is no commend to enter to make the build plate rise up after a certain amount of layers.
Reply
#3
(10-19-2019, 10:14 AM)lmenten Wrote: As someone made an updated the GCode for switching the fun during print only, would it be possible to have the build plate lift at a different height for an amount of first slices then every 100th (or more) slice? It would be great to be able to stop earlier a failed print.
 
just press pause of printing and the bed will rise showing the printing, press play again and printing will start again
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)