Hi everyone, I got a M2P yesterday - I could print the 2 towers no problem. Then I started to prepare my own first model. 3 failed prints so far. Fail 1: did not stick to the plate at all, so I releveld the printer and replaced foil on vat as I damaged it by removing the resin on it. See images below of fail 2 and 3.
As you can see the supports are not "sticking" to the "foundation plate". In one case at least some were printed, in the second try none.
I will try the towers again tomorrow and see if they print fine. It could also be an issue with the model. Anyone any ideas? Thanks
ps. I also have shiny sticky spots on the printed towers, I cured them first for 15 minutes in sunlight and then 5 minutes in the Elegoo Mercury curing station with UV, still sticky spots. Is this uncured resin?
As you can see the supports are not "sticking" to the "foundation plate". In one case at least some were printed, in the second try none.
I will try the towers again tomorrow and see if they print fine. It could also be an issue with the model. Anyone any ideas? Thanks
ps. I also have shiny sticky spots on the printed towers, I cured them first for 15 minutes in sunlight and then 5 minutes in the Elegoo Mercury curing station with UV, still sticky spots. Is this uncured resin?