Elegoo 3D Printers Forum › Troubleshooting › General Troubleshooting v
Problem with an Elegoo Mars

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Problem with an Elegoo Mars
fromFDMtoSLA Away
Member
***
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation: 8
#10
02-15-2020, 12:48 PM
can you measure the "LED-out" (voltage) from the mainboard with a multimeter?
if it's around zero, check again after starting the exposure-test.
Find
Reply


Messages In This Thread
Problem with an Elegoo Mars - by Interceptor - 02-13-2020, 01:16 PM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-14-2020, 07:22 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-15-2020, 02:40 AM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-15-2020, 03:18 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-15-2020, 09:45 AM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-15-2020, 09:59 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-15-2020, 10:05 AM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-15-2020, 10:36 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-15-2020, 12:25 PM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-15-2020, 12:48 PM
RE: Problem with an Elegoo Mars - by Interceptor - 02-15-2020, 01:54 PM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-15-2020, 02:48 PM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-16-2020, 04:45 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-16-2020, 05:07 AM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-16-2020, 05:19 AM
RE: Problem with an Elegoo Mars - by Interceptor - 02-17-2020, 01:37 PM
RE: Problem with an Elegoo Mars - by fromFDMtoSLA - 02-17-2020, 01:54 PM
RE: Problem with an Elegoo Mars - by Interceptor - 02-17-2020, 01:58 PM
RE: Problem with an Elegoo Mars - by Interceptor - 02-18-2020, 12:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)