02-22-2022, 07:50 AM
[attachment=500]Ok, new dilemma.
I think that I have an understanding now about shrinkage, and I make one print, measure it and come up with a percentage of shrink that I add to the next print. All has been working ok, except for the attached. This is perfectly round, so why is it shrinking in two different directions? I'm printing directly on a magnetic plate and no matter what settings I use, it still is out of round by about 2mm.
Any ideas?
I think that I have an understanding now about shrinkage, and I make one print, measure it and come up with a percentage of shrink that I add to the next print. All has been working ok, except for the attached. This is perfectly round, so why is it shrinking in two different directions? I'm printing directly on a magnetic plate and no matter what settings I use, it still is out of round by about 2mm.
Any ideas?