10-11-2021, 04:06 AM
Hi everyone, newbie here!!
I've a Mars 2 Mono, approx 2 months old, printed about 6 prints, all great. I upgraded the firmware when I received the machine & its worked great until now.
Suddenly for some reason when starting a print the build plate lifts off the FEP by 21mm after setting Z to Zero (which has worked fine on all the prints with a piece of A4 paper) so the initial layer now prints on the FEP as the build plate isn't there to form on?
I've tried re-running the good prints but the printer is doing the same action on all the prints? I've done dry runs so I can see & measure the build plate lift, there's nothing I can find online & the forums to explain this, is there a fault now with the printer, maybe the Z sensor?? There's no adjustment on the printer. I've tried reloading the firmware but it says it's on the current one.
Stumped !!!!!
Anybody else had this issue??
Thanks for any help !!
I've a Mars 2 Mono, approx 2 months old, printed about 6 prints, all great. I upgraded the firmware when I received the machine & its worked great until now.
Suddenly for some reason when starting a print the build plate lifts off the FEP by 21mm after setting Z to Zero (which has worked fine on all the prints with a piece of A4 paper) so the initial layer now prints on the FEP as the build plate isn't there to form on?
I've tried re-running the good prints but the printer is doing the same action on all the prints? I've done dry runs so I can see & measure the build plate lift, there's nothing I can find online & the forums to explain this, is there a fault now with the printer, maybe the Z sensor?? There's no adjustment on the printer. I've tried reloading the firmware but it says it's on the current one.
Stumped !!!!!
Anybody else had this issue??
Thanks for any help !!