11-05-2021, 07:50 PM
Hello,
Im not quite sure how to ask my question, so please bear with me.
After a print ends on my Saturn, the Z-axis raises the build plate up, but most of the time its not enough, and I need to manually move the z-axis. My question is if there is a way to change the instructions to the saturn, and tell it to raise higher after a print finishes.
Thank you!
Im not quite sure how to ask my question, so please bear with me.
After a print ends on my Saturn, the Z-axis raises the build plate up, but most of the time its not enough, and I need to manually move the z-axis. My question is if there is a way to change the instructions to the saturn, and tell it to raise higher after a print finishes.
Thank you!