12-09-2021, 09:59 PM
Greetings, just got my Mars 2 Pro today, I set it up, did the bed leveling, and started a print I sliced in lychee (a 20mm test cube on a 45 with supports), it failed when it got to the actual cube, seperated from the supports. I had no issue getting the supports off the build plate, however there was a little bit of print stuck to FEP, I carefully messed with it to get it off without damaging fep, I dunno why but I cleaned the vat (using warm water to fully clean it), but now I can't get a print to happen! I tried 3 times now and nothing appears. There is no failed print on the FEP, no print on the build plate. It's like UV isn't even making it to the resin. I did a test exposure and see the elegoo logo on exposure, I checked bed leveling that is fine, so no idea why it won't work at all now 
.
.