02-07-2022, 10:56 AM
Hi All-
I am printing on a Saturn with Siraya fast and directly on a magnetic build plate.
My prints are all over the place in dimensions. As much as 2mm smaller in the X axis and at least 3mm
in the Y axis.
My settings are 0.1 layer ht bottom count 5 Exposure 2.5 and bottom exposure 40s.
The part sticks to the plate no problem, and bending the magnetic plate, they pop off
but when I measure, it is way off.
Any help would be appreciated.
Ken
I am printing on a Saturn with Siraya fast and directly on a magnetic build plate.
My prints are all over the place in dimensions. As much as 2mm smaller in the X axis and at least 3mm
in the Y axis.
My settings are 0.1 layer ht bottom count 5 Exposure 2.5 and bottom exposure 40s.
The part sticks to the plate no problem, and bending the magnetic plate, they pop off
but when I measure, it is way off.
Any help would be appreciated.
Ken