09-05-2022, 01:14 AM
what I'm trying to share is how difficult the challenge is of 3D scanning for 3D printing.
If you are new then, Given that it's taken me all this time to master and know what I know about 3D printing and my last purchase was this, the thousands of dollars I've spent in the industry, the countless nights and hours, and here you are starting out
Agisoft Photoscan or 3df Zephyr are two program that I would recommend. I've used the latter and enjoy the simple workflow; it's very simple to use and learn.
The problem with scanners is that they can't scan in high detail, you can check details at printerhow so they lose a lot of information about the model. 3df Zephyr is capable of processing 1080p video and breaking it down into frames for processing, and it does so admirably.
If you are new then, Given that it's taken me all this time to master and know what I know about 3D printing and my last purchase was this, the thousands of dollars I've spent in the industry, the countless nights and hours, and here you are starting out
Agisoft Photoscan or 3df Zephyr are two program that I would recommend. I've used the latter and enjoy the simple workflow; it's very simple to use and learn.
The problem with scanners is that they can't scan in high detail, you can check details at printerhow so they lose a lot of information about the model. 3df Zephyr is capable of processing 1080p video and breaking it down into frames for processing, and it does so admirably.