02-25-2022, 02:41 AM
Hi Carl,
Apologies if this is obvious but , are you using the supplied spacer card between the build plate and lcd?
Some people prefer to set the plate level using the FEP only with tank in place (I'm not a fan of this)
Once the plate is set it is usually OK until something fails to print and shifts it slightly .
If none of the above apply , then have a search of the forum for instructions how to ZERO the Z axis and reset the HOME position.
Bill
Apologies if this is obvious but , are you using the supplied spacer card between the build plate and lcd?
Some people prefer to set the plate level using the FEP only with tank in place (I'm not a fan of this)
Once the plate is set it is usually OK until something fails to print and shifts it slightly .
If none of the above apply , then have a search of the forum for instructions how to ZERO the Z axis and reset the HOME position.
Bill