04-29-2022, 06:15 AM
(This post was last modified: 04-29-2022, 06:16 AM by grimbo_timbo.)
The build plate is stuck in the down position and I'm unable to lift it using the manual options under Tools. Its making a horrible loud brrrrr noise when I attempt to lift using the manual buttons. Looks like it got stuck in the down position about 15 minutes into a print (I came back to the room because I could hear the loud brrrrr noise)
Any ideas as to 1. whats caused it to stick and 2. how I go about fixing it.
I've had the printer a year to the day (it was a birthday present last year and it just so happens to be my birthday today.... and this happened
)
Any ideas as to 1. whats caused it to stick and 2. how I go about fixing it.
I've had the printer a year to the day (it was a birthday present last year and it just so happens to be my birthday today.... and this happened
)