05-30-2022, 11:14 AM
Hi All,
I have not used my Elegoo Mars for a couple of years, (I moved to a new country), and only used it a couple of times before that
But now I'm trying to get to grips with it, and I'm struggling.
My first attempt worked, but the two since then have nothing attached to the plate.
I cleaned the plate and the resin tank carefully with water and a clean dry soft cloth, and dried them. I shook the (water washable) resin thoroughly. The model preview looked good in the slicing software.
But nothing on the plate after 2 tries.
Though there WAS a thin layer outline on the bottom of the resin tank both times. (see photo attached)
I'm distinctly lost on what to try next - I'm unaware of anything different being done on the times that failed.
Is there a step by step idiots guide anywhere? Because this idiot is out of ideas...
All clues gratefully received,
Nick
I have not used my Elegoo Mars for a couple of years, (I moved to a new country), and only used it a couple of times before that
But now I'm trying to get to grips with it, and I'm struggling.
My first attempt worked, but the two since then have nothing attached to the plate.
I cleaned the plate and the resin tank carefully with water and a clean dry soft cloth, and dried them. I shook the (water washable) resin thoroughly. The model preview looked good in the slicing software.
But nothing on the plate after 2 tries.
Though there WAS a thin layer outline on the bottom of the resin tank both times. (see photo attached)
I'm distinctly lost on what to try next - I'm unaware of anything different being done on the times that failed.
Is there a step by step idiots guide anywhere? Because this idiot is out of ideas...
All clues gratefully received,
Nick