Print dosent stay attached to suppots

[CollinsA]

Thanks for the reply, I will give these a shot.

Have you good results alreadY?

It appears to me that there needs to be a massive amount of supports needed. I'm having a difficult time with finding a balance. One thing for sure seems to be that the Light and Medium are worthless have only had success with Heavy. Then you run into the issue of removing the huge number of supports. Just to clarify that I'm not trying to print characters where the bottom is not really an issue but more functional engineering models where the supports tend to be a issue. Printing off the build plate would be preferred if only it would print the model to the correct thickness. I will acknowledge that I made a mistake early on with not re-zeroing after leveling, I thought that this step would have solved my issue, however it has not. Models are still around 1-1.5mm short in Z. So the only way that I'm able to get proper dimensional parts is to build with supports, which adds height to the build which adds more time and more cleanup.