Alternate slicer options?

Current time: 05-17-2024, 05:03 AM Hello There, Guest! Register

Thread Rating:

0 Vote(s) - 0 Average

Thread Modes

Alternate slicer options?

nitehawk Offline

Offline

Junior Member

Posts: 1
Threads: 1
Joined: Sep 2019
Reputation: 0

#1

09-25-2019, 11:29 AM

Has anyone been able to get Prusa Slicer to work with the Mars? I'm assuming it would need an alternate firmware to make this happen, however, it would greatly simplify my process to be able to work in a single slicing platform.

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Alternate slicer options? - by nitehawk - 09-25-2019, 11:29 AM

RE: Alternate slicer options? - by Geekdad_3D - 10-04-2019, 08:08 AM

RE: Alternate slicer options? - by djpsyc - 10-15-2019, 09:17 AM

RE: Alternate slicer options? - by Jroze88 - 12-25-2019, 06:28 AM

RE: Alternate slicer options? - by Van Valen - 10-28-2020, 11:35 AM

RE: Alternate slicer options? - by JasonsBigBox - 10-31-2020, 05:08 AM

RE: Alternate slicer options? - by plate-of-shrimp - 11-01-2020, 07:58 AM

RE: Alternate slicer options? - by sn4k3 - 11-26-2020, 09:52 AM

RE: Alternate slicer options? - by Two Wheeler - 02-18-2021, 05:35 AM

RE: Alternate slicer options? - by cliffyk - 02-18-2021, 07:20 AM

RE: Alternate slicer options? - by The grim one - 08-28-2022, 09:34 AM

RE: Alternate slicer options? - by cliffyk - 08-28-2022, 10:06 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 2 Guest(s)