Thread Rating:
  • 1 Vote(s) - 5 Average
Ethernet Enabled Printing (Support for ChiTuBox 1.4.0 + 1.5.0)
#37
Brick 
how can we remove the epax and return to normal? I tried to reset the normal firmwrae but it does not change anything

because I have a print problem arrived at 6 min of print it stops alone as if I had to stop the print

(09-10-2019, 11:57 PM)fips Wrote: Hello, everyone.

My firmware is V4.2.16_LCD /1440x2560 /F2.0

i try to install the fpga xxx.bin but i always get the error message: error "no authorization!".

i tried the release:
Mars V4.2.16_LCD /1440x2560 /F2.7
and
MARS EPAX NETWORK ENABLED CHITUBOX 1.4.0 + 1.5.0.zip

does anyone have any idea how I can proceed to activate the network?

tries to come back in 4.18 I had that same concern at the beginning
Reply


Messages In This Thread
RE: Ethernet Enabled Printing - by Simoncox - 07-21-2019, 04:47 PM
RE: Ethernet Enabled Printing - by Lecoyote - 07-21-2019, 06:16 PM
RE: Ethernet Enabled Printing - by admin - 07-21-2019, 06:47 PM
RE: Ethernet Enabled Printing - by admin - 07-21-2019, 06:54 PM
RE: Ethernet Enabled Printing (Support for ChiTuBox 1.4.0 + 1.5.0) - by serial59 - 09-11-2019, 08:06 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)